Pop-up Greeting Cards
A 10 Γ 14 cm folded card with one measured pop-up panel that lies flat when it closes.
- Beginner
- 30β45 min
- $3β$8 USD (11β29 AED)
Make it yourself
Simple ideas. Creative projects. Step-by-step guides. Make it yourself!
Counts come from the projects published on this page.
A short editorial pick. JiffHub does not collect views or ratings.
A 10 Γ 14 cm folded card with one measured pop-up panel that lies flat when it closes.
A USB LED strip in a cardboard channel, with tracing paper as a diffuser, for a shelf or headboard.
A rinsed drink bottle, turned into a planter with a cotton wick and a visible water reservoir.
A 20 Γ 12 Γ 10 cm cardboard tray with four compartments for pens, clips, and notes.
Every project in this set is beginner. These are the shorter ones.
A rinsed drink bottle, turned into a planter with a cotton wick and a visible water reservoir.
Three adhesive clips and one mount that keep light desk leads along a 30 cm zone.
A 20 Γ 12 Γ 10 cm cardboard tray with four compartments for pens, clips, and notes.
A 10 Γ 14 cm folded card with one measured pop-up panel that lies flat when it closes.
Sorted by the low end of each illustrative cost.
Estimate; varies by location. The dirham figure uses the UAE peg of 3.6725 per US dollar, rounded to the nearest dirham. It is not a shop quote.
A 20 Γ 12 Γ 10 cm cardboard tray with four compartments for pens, clips, and notes.
A 15 Γ 20 cm cardboard frame with a 9 Γ 14 cm window for a 10 Γ 15 cm photo.
A 10 Γ 14 cm folded card with one measured pop-up panel that lies flat when it closes.
A rinsed drink bottle, turned into a planter with a cotton wick and a visible water reservoir.
Newest published date first.
A 2 mm cardstock box, about 12.4 Γ 8.4 Γ 5.2 cm outside, with a lid that slides on.
A 15 Γ 20 cm cardboard frame with a 9 Γ 14 cm window for a 10 Γ 15 cm photo.
A 10 Γ 14 cm folded card with one measured pop-up panel that lies flat when it closes.
Three drained pots of culinary herbs in a 52 cm row, with mint in its own pot.
Four habits that save a project. Not a separate article.
Put the pieces together before any glue. A pencil line can be erased. A twisted joint usually cannot.
After the first panels are glued, measure the opening you have. Cardboard thickness changes the inside, and the divider should match that reading.
A metal ruler and a sharp blade, on a mat, beat scissors that crush the edge. A crushed edge leaves a gap at the corner.
Write the part name in pencil on the back before you add paper. Decoration hides the marks you needed.